5mm Beveled Edge Wedding Band in Solid 14K Gold
A flat polished face with both outer edges chamfered away, cast in solid 14K gold at a 5mm width. The bevel is a small cut that does a lot of work: it breaks the hard corner where the face meets the side, so the band picks up a second and third angle of light without losing the clean flat top. At 5mm there is enough surface for all three planes to read clearly. Handcrafted to order in our Woodside, Queens workshop.
The Beveled Profile
The center of the band stays flat and level, and the two edges are cut back at an angle to form narrow facets running the full circumference. That gives you three surfaces where a flat band has one — a bright plateau across the top and two dimmer flanks that shift as your hand moves. The result reads as architectural rather than ornamental. There is nothing applied to the ring and nothing set into it; the whole effect comes from how the metal is cut.
Why 5mm
A bevel needs width to work. On a narrow band the two chamfers eat most of the face and the flat plateau nearly disappears; at 5mm the proportions come right — a broad center with two clean facets framing it, all three clearly separated. This is the width where a beveled band stops reading as a plain ring with softened corners and starts reading as a deliberate geometric design. If you want the same profile slimmer, we make it as the 4mm Beveled Edge Wedding Band, and our guide to 4mm vs 5mm vs 6mm wedding bands works through the width decision properly.
Polished or Satin
We make this same bevel with a brushed satin face. The choice is a real one. Polished gives you maximum brightness and the more traditional, dressier read, but a mirror surface shows fine scratches as it wears — and the flat plateau on a beveled band is exactly the kind of uninterrupted plane where they show worst. The 5mm Beveled Satin Wedding Band trades that brightness for a matte surface that absorbs them. If you want the ring to catch the eye, choose this one. If you work with your hands, choose satin.
How It Differs From a Knife-Edge
These two are confused more than any other pair we make. A bevel chamfers the corners and keeps the flat plateau across the top. A knife-edge removes that plateau entirely and runs both faces up to a central ridge. Choose the bevel if you want a flat surface with the sharp corners taken off — it is the more conservative of the two, and the better choice if the ring needs to read as a traditional wedding band. Choose the knife-edge if you want the band itself to have an edge.
Fit and Comfort
The interior is comfort-fit, gently domed rather than flat, so it clears the knuckle without dragging and sits without pressure points through a long day. The beveled corners help here too: with the edges cut back, there is less of a hard rim to catch on the fingers on either side — which matters more at 5mm than at narrower widths.
Choosing Your Metal
Yellow gold gives the flat top its warmest read and keeps the whole band traditional. White gold sharpens the contrast between the plateau and the two beveled flanks, which makes the geometry more visible and the ring more modern. Rose gold sits between them. Each band is cast in the metal you choose, solid throughout — never plated, never gold-filled.
Made to Order in Queens
We hold no inventory. When your order arrives, this band is cast in your size and your metal, then the bevels are cut and the faces polished by hand at our bench in Woodside. Production runs two to three weeks before it ships free and fully insured. Every piece carries a lifetime warranty on workmanship and free resizing, and non-engraved bands can be returned within fourteen days.
A Width or Finish We Don't List
If you want this bevel wider, or as a slimmer matching band for a partner, write to me. I cut these one at a time — the width is a decision, not a limitation. Call or text 929-806-1502, or email info@blackpearlofqueens.com.
